Aaeon PFM-C20N Manual de usuario descargar pdf (Pagina 30)

CAN Bus Module PFM-C20N

Chapter 3 Driver Installation 3 - 5

The setting of Base Address has to be the same as Jumper

setting.

IRQ only support POLLING.

The Baud Rates of Transmit Port and Monitor Port have to be the

same.

For Mode, you may choose “Basic” or “Peli” (only Peli can transmit

“Extended frame”). The default setting of “Mode” is “Basic.”

The Acceptance Code and Mask will be varied by the “Mode” you

set. For example, “Basic” is 8 bits, Peli is 32 bits. You may

choose the default setting if the application has no specific request.

You may click on “OK” after finish setting these values.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 43 44

Sin comentarios

Aaeon PFM-C20N Manual de usuario Pagina 30